[Elecraft] K3 adjust advice

[Greg - AB7R]

The Auto-Spot function performs best when the filter is narrow.  I find no problems 
when the filter is set at 500 Hz.  It also works in PSK but not (yet) for FSK.

-------------------------
73,
Greg - AB7R
Whidbey Island WA
NA-065
K3#0009

On Fri Feb 15  5:46 , dj7mgq at muenchen-mail.de sent:

>Hi Charles,
>
>You might want to try k3support at elecraft.com> (or  
>support at elecraft.com>) for numbers one and two.
>
>
>Concerning #1) Do you have NR turned on when you hear the bursts?  
>There was a problem with this several firmware revisions ago.
>
>
>Concerning #2) Here in Europe I have not noticed anything like this,  
>and there are medium and short wave transmitters roughly 4 to 5 miles  
>from our club station, where I usually have my K3. Are you sure that  
>these products are being produced in your K3 and, for example, not by  
>oxidized connectors or the like?
>
>
>> Do not know how to adjust the manual notch.
>
>It's in the manual, page 24: Hold MAN to adjust the manual notch frequency
>using VFO B. This also selects manual notch.
>
>
>> Auto SPOT seems not to work every time
>
>My experience is, if a signal is not strong enough or if there is more  
>than one signal audible then it does have problems auto-tuning.
>
>
>vy 73 de toby
>
>_______________________________________________
>Elecraft mailing list
>Post to: Elecraft at mailman.qth.net
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft    
>
>Help: http://mailman.qth.net/subscribers.htm
>Elecraft web page: http://www.elecraft.com