[Elecraft] K3 Error msg

[Don Wilhelm]

Bill,

Do you have the correct filter set for SSB transmit? - it sounds like 
you do not.  ERR TxF means transmit filter error!  The 2.7/2.8 kHz 
filter must be selected for SSB and CW transmit.  See the menu entries 
on page 51 "FLTX".  If you placed your 2.7/2.8 filter anywhere other 
than the FL1 position, this menu entry must be changed from the default 
position of FL1.

73,
Don W3FPR

KXB wrote:
> Well...I've twisted something out of sequence. (was in the config menu before this happened) I get "ERR TxF"...  SSB phone, any band, dummy load.  Locks out the xmtr after the first key-up . I don't see it in the manual In the Error Msg. list. (page 58) 
> Any suggestions will be greatly appreciated.
>
> BillHarris 
>
>