[Elecraft] K3 Rx Antenna Isolation

[Barry N1EU]

Perhaps Ed will clarify, but my take is that Ed's post is a different issue. 
I believe he is saying that while he's in RECEIVE mode with the RX ANT
selected, there's leakage of the receive signal on the transmit antenna
feedline into his receiver - poor isolation in the receive antenna
selection.

Personally, I haven't seen this but I haven't listened specifically for it
either.

73,
Barry N1EU



Gary W. Hvizdak wrote:
> 
> On Fri 8 Feb 2008 at 01:07:35 EST, Ed Gilliland (W5TM) wrote ..
> 
> I'm have poor isolation between the transmit antenna (ANT1) and my
> Beverage
> (RX ANT IN).  I have to switch to ANT2 to get rid of the noise from the
> transmit antenna.  As new as I am to the K3 I may have an option set
> wrong.
> 
> --
> 
> Ed,
> 
>     Wayne's recent post entitled "KXV3: (1) RX ANT signal level during TX;
> (2) spectra at buffered IF output" may address your question.  You can
> find his post in the online Reflector archives at ...
>     http://mailman.qth.net/pipermail/elecraft/2008-February/082024.html
> 
> 73,
> Gary  KI4GGX
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> 
> 

-- 
View this message in context: http://www.nabble.com/K3-Rx-Antenna-Isolation-tp15350020p15354381.html
Sent from the Elecraft mailing list archive at Nabble.com.