[Elecraft] Key-Out of the K3

[David Pratt]

I have tried semi-QSK, Mike, but still get the XV144 relay clatter at 
speeds less than about 24wpm.  I can't find in the manual which config 
command I need to change the release delay. Can you point me to it 
please?  I would like to stop the XV144 relays switching between Morse 
elements at 18-20wpm.

73

David G4DMP

In a recent message, Mike Harris <mike.harris at horizon.co.fk> wrote ...
>
>| I agree there, Bob.  Using the K3 with the XV144 on CW, the XV relays
>| clatter with every dot and dash which did not happen with the K2.  I am
>| a bit worried that it can't be doing the XV144 relays much good.
>
>Correct me if I'm wrong but aren't we mixing up two delays here?
>Currently there isn't an adjustable "PTT on/carrier up" delay on the K3,
>this is the same for the K2, approx 10ms if I remember correctly.  But did
>I not read that in semi break-in with the K3 you can adjust the release
>delay.  That should stop the relays rattling.
-- 
David G4DMP
Leeds, England, UK
------