[Elecraft] Firmware request KRC2

[Don Wilhelm]

Mike,

Try it using the AUXBUS control before connecting the BAND0-3 outputs 
from the ACC connector.
If I recall, the AUXBUS control will also activate the 60 meter KRC2 
output when 6 meters is selected on the K3.

Even if my memory is incorrect, it is worth a try, it is an easy matter 
to connect the AUXBUS signal from the K3 to the KRC2.

73,
Don W3FPR

AD6XY wrote:
> 
> That is a very good idea Joe.
> 
> I will try but it will need pull up resistors fitting in the KRC2. Also
> because I use transverters I will have to solder 4 more wires and it will
> need two multicore cables soldering onto that 15 way din and that is very
> difficult because of the size with a connector designed for only one cable.
> I will also need to put an ALC line in there once the ALC +- issue is
> finalised. I had hoped only to have the K3 linked simply through the KRC2 to
> my transverters (like for my K2). 
> 
> If only the non-atu version of the K3 had two outputs.
> 
> Mike
> 
> 
> 
> ------------------------------------------------------------------------
> 
> 
> No virus found in this incoming message.
> Checked by AVG - http://www.avg.com 
> Version: 8.0.169 / Virus Database: 270.6.13/1642 - Release Date: 8/29/2008 6:12 PM
>