[Elecraft] K3 TX challenge

[Bob Cunnings]

Normal behavior - monitor setting is independent of TEST mode. If you
don't want to monitor your own voice, turn MONITOR down.

Bob NW8L

On Sat, Aug 23, 2008 at 11:24 AM, Jim Cundiff <dadofpetie at comcast.net> wrote:
> Hey All,
> I could use a little direction here please!
>   I had a bad mike from the factory, an MH2 ordered with radio. After
> working with Scott @ Elecraft, he sent me a replacement. I had nothing out
> of the first mike.
>
> Second mike plugged in and radio placed in test mode.
> Successfully went thru procedure to set up mike, ALC and CMP levels using
> the speaker and not headphones.
>
> Here is where things went sideways. After exiting test mode (TX arrow not
> blinking), I was able to make a good QSO to S. Carolina (5/7) BUT my own TX
> is coming out of my speaker just like when in test mode! RX audio is blocked
> and I hear me. I am sure something I did is causing this. Any ideas on what
> is going on? Thanks for any help. 73.
>
> In His service,
> Jim Cundiff KB3GFC
> K3 # 1264
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>