[Elecraft] K3 switches off during high power TX gain calibration

[Brett Howard]

Are you sure your power supply isn't sagging too much?  Can you supply
enough current for the rig?

On Sat, 2008-08-16 at 21:06 +0200, Dick Grolleman wrote:
> Hi All
> 
> I finaly had my K3 working after five weeks and several replacement boards at 10 watts. I just installed the 100 PA. I'm up to do the high power TX Gain calibration
> 
> Started on 160, wich was ok. But have trouble on 60, 30 and 6m. When I press tune, the radio switches off it self. 
> 
> Any one else had this problem? Any info is welcome
> 
> It sure takes a long time this way to get the K3 working received it 5 weeks ago, and still not finished
> 
> 73 de Dick PA3FQA
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com