[Elecraft] K3 switches off during high power TX gain calibration

[Dick Dievendorff]

Are your power supply and the connections to that supply adequate?  Monitor
the supply voltage (using the K3 display) to see what happens when you press
Tune. I'm guessing that the voltage may be dropping.

Dick, K6KR


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Dick Grolleman
Sent: Saturday, August 16, 2008 12:07 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] K3 switches off during high power TX gain calibration

Hi All

I finaly had my K3 working after five weeks and several replacement boards
at 10 watts. I just installed the 100 PA. I'm up to do the high power TX
Gain calibration

Started on 160, wich was ok. But have trouble on 60, 30 and 6m. When I press
tune, the radio switches off it self. 

Any one else had this problem? Any info is welcome

It sure takes a long time this way to get the K3 working received it 5 weeks
ago, and still not finished

73 de Dick PA3FQA
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com