[Elecraft] re position of roofing filters on KRX3 2nd rx

[Fern Rivard]

Ok Dick, many thanks for that info.  Much appreciated.   Fern


----- Original Message ----- 
From: "Dick Dievendorff" <dieven at comcast.net>
To: "'Fern Rivard'" <crc at cyberlink.bc.ca>; <elecraft at mailman.qth.net>
Sent: Tuesday, August 12, 2008 9:02 AM
Subject: RE: [Elecraft] re position of roofing filters on KRX3 2nd rx


There is a shield that surrounds the RF receiver board that the filters are
mounted to.

The KRX3 has a few other boards that remain in place, but the main shielded
RF board has to come out to change filters.  

With practice the shielded board comes out very quickly. 

Dick, K6KR


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Fern Rivard
Sent: Tuesday, August 12, 2008 7:57 AM
To: elecraft at mailman.qth.net
Subject: [Elecraft] re position of roofing filters on KRX3 2nd rx

Are the roofing filters accessible on the KRX-3 receiver without having to
pull the receiver out of the K3?  Thanks from Fern

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com



-- 
No virus found in this incoming message.
Checked by AVG Free Edition. 
Version: 7.5.516 / Virus Database: 270.6.1/1607 - Release Date: 8/12/2008 7:19 AM