[Elecraft] K3 rough note on CW monitor

[n4lq]

So I assume you are using one serial port to control the K3 and another to 
key it? Perhaps the PC is busy doing other task at times. This is why a lot 
of hams buy the Winkey keyer. I've been able to get by ok by using the 
parallel port on the pc and the LPT adapter from Hose Nose.
Steve Ellington
N4LQ at insightbb.com
----- Original Message ----- 
From: "Julius Fazekas" <phriendly1 at yahoo.com>
To: <elecraft at mailman.qth.net>
Sent: Monday, August 11, 2008 10:05 AM
Subject: [Elecraft] K3 rough note on CW monitor


> This weekend I noticed that the CW sound was distorted and full of 
> artifacts. This was listening to my own sending via headphones, keying was 
> via N1MM through the serial port.
>
> I'm using MCU 2.22 / DSP 1.88.
>
> Any thoughts?
>
> thanks,
> Julius
>
> Julius Fazekas
> N2WN
>
> Tennessee Contest Group
> TnQP http://www.tnqp.org/
>
> Elecraft K2/100 #3311
> Elecraft K2/100 #4455
> Elecraft K3/100 #366
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
> No virus found in this incoming message.
> Checked by AVG - http://www.avg.com
> Version: 8.0.138 / Virus Database: 270.6.0/1604 - Release Date: 8/11/2008 
> 5:50 AM
>
>
>