[Elecraft] K3 w/Aluminum Spinner?

[Ralph T. Stetson III]

Ron & Don

Does this mean there is a degree of Mojo to found in the K3 after all this 
wonderful dialogue of why this or that nit doesn't work?

I certainly hope so My K2 and K1 are sitting here doing the Mojo thing every 
time I turn them on.

Guess I can now entertain thoughts of getting a QRP K3 to round out my 
family of Elecraft products.

Been holding off as I have been known to whine with the best of the best 
about truly insignificant things in the past.

And then finding it was due to my repeated lack of following the directions 
in the manual (you know RTFM) that was causing me to go astray.

Also found out that by not starching the briefs the personal stress factor 
was greatly reduced as well, but that's another story.

so back into the wood work I go.

Ralph Stetson, KD1R

NW VT

----- Original Message ----- 
From: "Ron D'Eau Claire" <ron at cobi.biz>
To: "'Don Rasmussen'" <wb8yqj at yahoo.com>; <elecraft at mailman.qth.net>
Sent: Sunday, August 10, 2008 3:17 PM
Subject: RE: [Elecraft] K3 w/Aluminum Spinner?


> Gee, Don, his comment might have been a bit abrupt, but keep in mind that
> many members of this list are on dial-up. Some even pay for each byte
> downloaded no matter how fast the connection.
>
> It does seem that 2,000 by 3,000 pixel WEB image is a bit "overkill".
>
> Nice disk though.
>
> Experience with the K2 suggests that when an Elecraft rig reaches the 
> point
> where people start fiddling with the knob aesthetics, it's "arrived"!!
>
> 73,
>
> Ron AC7AC