[Elecraft] K3 Headphone Jack

[Chuck - AE4CW]

Barry, I used a "trim" washer (very thin) from a spare headphone jack I had
laying around to fill the gap.  As I recall it was about 0.018" thick and
was perfect.  The knurled nut tightened down without deforming the front
panel at all.

Chuck, AE4CW


Barry Simpson wrote:
> 
> I am progressing quite well with my assembly but I have just come across
> the
> headphone jack loose washer issue. Is there a recognised cure. Can you
> leave
> the washer out altogether or do you need another nut or washer to make it
> tighter.
> 
>  
> 
> Any help would be appreciated before I move on to the next stage.
> 
>  
> 
> Thanks
> 
>  
> 
> Barry Simpson  VK2BJ
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> 
> 

-- 
View this message in context: http://n2.nabble.com/K3-Headphone-Jack-tp680204p680660.html
Sent from the Elecraft mailing list archive at Nabble.com.