[Elecraft] K3: cheapo substitute for KXV3?

[Burl]

Yes.  It is the same cable they use for the KXV3 oprtion.

Burl  AJ9Q

----- Original Message ----- 
From: "Iain MacDonnell - K6IAM" <k6iam at dseven.org>
To: "Burl" <borch at mchsi.com>
Cc: "DOUGLAS ZWIEBEL" <dougzzz at gmail.com>; "Elecraft Reflector" 
<elecraft at mailman.qth.net>
Sent: Thursday, August 07, 2008 6:05 PM
Subject: Re: [Elecraft] K3: cheapo substitute for KXV3?


>
> With this cable for the IF out, would one be able to feed a LP-PAN with
> full functionality without the KXV3 option?
>
>     ~Iain
>
>
> Burl wrote on 08/07/08 15:39:
>> You can purchase the cable (pn850292 @$3.10) from Elecraft that will plug 
>> into the bottom of RF board at P86.  This is the same cable used for the 
>> KXV3 option.  It has the 2 pin connector on one end and the other end can 
>> be soldered to a BNC connector.    A BNC connector can easily be mounted 
>> in the location of the blank plate that would be used for the KXV3 option 
>> on the back of the radio.
>>
>> Burl  AJ9Q
>>
>> ----- Original Message ----- From: "DOUGLAS ZWIEBEL" <dougzzz at gmail.com>
>> To: "Elecraft Reflector" <elecraft at mailman.qth.net>
>> Sent: Thursday, August 07, 2008 1:53 PM
>> Subject: [Elecraft] K3: cheapo substitute for KXV3?
>>
>>
>>> Okay...so I a typical "cheap" ham....
>>>
>>> I would like to save some $$ while still being able to access the "IF
>>> OUT" from the K3.  Is there a less expensive (home brew) way to do
>>> this?  I don't need any of the xvtr functionality, etc.  Just want the
>>> IF output.
>>>
>>> I hope Eric and Wayne don't get too upset with this post, but, ummm,
>>> it is still "hands on radio," right?  Can anyone help out this non-EE,
>>> non-RF engineer type guy?
>>>
>>> :-)
>>>
>>> Mni tnx....
>>> de Doug KR2Q
>>> _______________________________________________
>>> Elecraft mailing list
>>> Post to: Elecraft at mailman.qth.net
>>> You must be a subscriber to post to the list.
>>> Subscriber Info (Addr. Change, sub, unsub etc.):
>>> http://mailman.qth.net/mailman/listinfo/elecraft
>>>
>>> Help: http://mailman.qth.net/subscribers.htm
>>> Elecraft web page: http://www.elecraft.com
>>>
>>
>>
>> _______________________________________________
>> Elecraft mailing list
>> Post to: Elecraft at mailman.qth.net
>> You must be a subscriber to post to the list.
>> Subscriber Info (Addr. Change, sub, unsub etc.):
>> http://mailman.qth.net/mailman/listinfo/elecraft   Help: 
>> http://mailman.qth.net/subscribers.htm
>> Elecraft web page: http://www.elecraft.com
>