[Elecraft] K3: cheapo substitute for KXV3?

[Burl]

You can purchase the cable (pn850292 @$3.10) from Elecraft that will plug 
into the bottom of RF board at P86.  This is the same cable used for the 
KXV3 option.  It has the 2 pin connector on one end and the other end can be 
soldered to a BNC connector.    A BNC connector can easily be mounted in the 
location of the blank plate that would be used for the KXV3 option on the 
back of the radio.

Burl  AJ9Q

----- Original Message ----- 
From: "DOUGLAS ZWIEBEL" <dougzzz at gmail.com>
To: "Elecraft Reflector" <elecraft at mailman.qth.net>
Sent: Thursday, August 07, 2008 1:53 PM
Subject: [Elecraft] K3: cheapo substitute for KXV3?


> Okay...so I a typical "cheap" ham....
>
> I would like to save some $$ while still being able to access the "IF
> OUT" from the K3.  Is there a less expensive (home brew) way to do
> this?  I don't need any of the xvtr functionality, etc.  Just want the
> IF output.
>
> I hope Eric and Wayne don't get too upset with this post, but, ummm,
> it is still "hands on radio," right?  Can anyone help out this non-EE,
> non-RF engineer type guy?
>
> :-)
>
> Mni tnx....
> de Doug KR2Q
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>