[Elecraft] K2 power setting for SSB QRP?

[TF3KX]

I would like to establish the "correct" setting for transmitting proper QRP
SSB signals from my K2.

I have seen earlier discussions on the definition of QRP for SSB signals,
where the majority seem to set it at 10W PEP (presumably close to 5W average
power), while a few adhere strictly to the notion that no more than 5W
should enter the antenna terminals at any time.

At any rate, this brings me to the question:  If I adjust the power level of
my K2 to, say, 5W, using the power knob, will the rig then actually send out
SSB at 5W PEP, 5W average, or something else?

73 - Kristinn, TF3KX
-- 
View this message in context: http://n2.nabble.com/K2-power-setting-for-SSB-QRP--tp678796p678796.html
Sent from the Elecraft mailing list archive at Nabble.com.