[Elecraft] N1MM Com Port CW

[g4mkp]

Thanks for the assistance. Still can't get it to work with software switches
so will look at the hardware interfacing and go through the set-up again in
detail.

Cheers,

Terry
G4MKP



> 
> I would like to move away from LPT keying which consists of a 
> simple homebrew transistor circuit and use the (or at least 
> try) serial port keying using N1MM
> 
>  
> 
> I have configured N1MM software thus:
> 
> Elecraft K3 on Com1
> 
> CW box ticked
> 
> Speed 38400
> 
> Parity N
> 
> Databits 8
> 
> Stop bits 1
> 
> DTR always off
> 
> RTS always off
> 
> Radio 1
> 
> Footswitch (pin6) None
> 
> CW/PTT Port Addr F38
> 
>  
> 
> Rig control works ok but it's not keying the transceiver. Now 
> go easy on me men I know that it's soooooo obvious to someone 
> what I have/haven't done but I'm buggered if I know what it is.
> 
>  
> 
> Cheers,
> 
>  
> 
> Terry
> 
> G4MKP
 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com