[Elecraft] Firmware glitch on Xtal Filter selection?

[williamsonr at pbtcomm.net]

I recently completed my K3 #1318 and updated to the latest firmware.  On another post to this group I recall someone (Dr. Garland?) asking about the same issue I am seeing on my rig.  I have set up xtal filters as follows FL1 - open but assigned to FM (FM filter back ordered) FL2 2.7 kHz, FL3 1.8 kHz, FL4&5 empty.  I have set up the filter receive assignments per mode and the TX filter assignments as per the manual.  Here is what I am experiencing.  Any time I go into the config menu for any changes(and maybe the main menu as well - can't recall) when I come out of the menu the filter auto selection during DSP bandwidth changes acts odd (In SSB mode for sure, I haven't noticed other modes).  i.e. selecting a DSP bandwidth wider than 2.7 kHz now selects the FL1 position which is empty! Receiver goes dead! If I simply press the band up or down button and try this again the rig now performs correctly and ignores FL1 that is not assigned to SSB or CW etc.  All remains well until I!
!
 go into the Config menu again???

Rodger
N4NRW