[Elecraft] Squelch

[Joe Planisky]

Hi Tom,

Yes, the K2 has a Squelch feature.  It's accessed through the  
secondary menu (tap MENU, then tap DISPLAY).  Squelch (SLCH) is the  
first item on the secondary menu.   See page 100 in the K2 manual.

73,
Joe KB8AP

On Apr 30, 2008, at 6:54 PM, KJ3D wrote:

> Hello Group,
>
> I recently installed HSE software and ran into an interesting  
> problem.  The
> folks at Callsign Software couldn't provide a solution, so here I am.
>
> After the installation, when the K2 was powered up, it would do so  
> with no
> audio - but otherwise apparently working fine.  A touch on the key  
> or PTT
> switch brought it back to life, but only for 10 seconds).
>
> Somehow, the HSE program turned squelch full on on my K2 (ser 4991  
> with SSB
> and DSP).
>
> I cannot find a reference to squelch anywhere in the Elecraft  
> literature,
> including how to turn it off.
>
> I did get it off, but it required installing HRD and installing all  
> the
> sliders.  One is for squelch and it was full on.  Turning it off and  
> exiting
> the program solved the problem.
>
> My question is...
>
> What's the story on squelch?  Is there one?  How does one access it -
> specifically how do you turn it off if it gets turned on by a third  
> party?
>
> TIA,
>
> 73,
>
> Tom, KJ3D
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com