[Elecraft] K3 Front panel rattling washer

[Windy Dankoff KM5Q]

LOOSE PHONES JACK AND WASHER RESOLVED!

I removed the left side panel to see what's up. So there is a very small gap
due to slight bowing forward of the front panel. Again I could squeeze it
shut with my fingers and re-tighten the nut, but that's not adequate.
Lacking a hex nut, I placed cloth over the round nut and tightened it
carefully with pliers. It's fine for now.

Why not simply supply a hex nut and flat washer? It would make it safe, easy
and secure.

Windy KM5Q
-- 
View this message in context: http://www.nabble.com/K3-Front-panel-rattling-washer-tp16964678p16987379.html
Sent from the Elecraft mailing list archive at Nabble.com.