[Elecraft] K3 #764 experience and critique

[KM5Q]

First, I'm delighted with the whole K3 experience. It's a brilliant  
product, worth the wait.

I have a few issues and suggestions:

1. Several times I found myself doing a complex assembly step in my  
hands while reading the instructions. An important point would show up  
late in the paragraph, and I wished I had read it all first (but I  
couldn't resist). If important points were emphasized in BOLD print, I  
would have  been more likely to read them first.

2. The final multi-plugging of the front panel was the only challenge  
I experienced. I knew it would be tricky, after reading about it in  
the reflector. Because I knew this, I took extra time and did it with  
confidence. Had I NOT known it was tricky, I would have felt clumsy  
and frustrated. I suggest noting in the instructions that this IS a  
tricky step and if the builder is getting tired, take a break first,  
and take it SLOW.

3. VFO A encoder uses an inside-tooth lock washer on each side of its  
mount. This caused mine to come out slightly off-90° when tightened  
(using a box-end wrench). I noticed it only when I mounted the knob  
with the felt washer and it rubbed on one side. I spaced it out  
slightly further with cardboard. It's OK, but this could have been  
avoided somehow.

4. Headphone jack on front panel isn't tight enough. Instructions are  
to tighten the ring-nut only finger-tight. I have pretty strong  
fingers, but that doesn't do the trick. If I use a hex-nut, will it  
squeeze the panel too much?

5. K3 is advertised as a no-solder kit, so it should not require  
soldering (or a $100 crimp tool) to make the Powerpole connection.  
That should be done at the factory.

I soldered mine, using high temp. quickly, so it wouldn't wick much  
solder up the cable. A builder who does not have good soldering skills  
is likely to have trouble.

6. KUSB adapter instructions make no mention of Mac application. They  
should mention that the Prolific.com site has driver download for Mac  
OSX as well as other PCs, and that it is necessary.

7. When I turn down the compression, the power goes down with it. It  
should be equalized.

8. When I tune out of a ham band to listen elsewhere, then hit band  
switch, band switch will not return to the nearby ham band, but to the  
out-of-band frequency. Others reported this a few days ago. I expect  
that will get fixed in firmware.

9. I did frequency calibration by zero-beat method with WWV. I tuned  
the wrong way and didn't know it would take many turns. I didn't write  
down the original setting, so I got "lost". I waited until I had a  
steadier WWV signal, then went in the other direction and got it  
perfect. I suggest that the instructions say that it may take many  
turns of the knob, and that you should write down the original setting  
first.

In conclusion, the only issue I'm left with is the loose headphone  
jack. Not too bad!

I have a Kenwood MC-43S fist mike with the 8-pin connector standard. I  
plugged it in and it works fine. My first QSO was with another K3 at  
the super-station in Visalia  :-) I also checked into the Sunday  
Elecraft SSB Net. I've gotten all excellent audio reports.

I just retired my Ten Tec Triton IV. I feel like Rip Van Winkle,  
awaking from the 1970's.
Windy KM5Q