[Elecraft] S/N 687 1st PSK31 Contact

[Don Ehrlich]

The K3 manual suggests putting a resistive divider in the audio output line 
from the computer.  I installed a 10:1  divider using a 1Kohm and a 100 ohm 
resistor and it made it a lot easier to adjust the mic input gain so that I 
got none-to-one bars AGC.

Don K7FJ



------------------
My only complaint with the K3 is that is requires very little audio input to 
get to 50 Watts!  Had the LINE IN setting on 1 and the computers MAIN Volume 
and WAVE OUTPUT way down.  Can this be changed with different firmware?  It 
would be nice to be able to leave the computer's level alone, and be able to 
have more range with the K3's controls...