[Elecraft] (no subject)

[Chuck Gehring]

Steve,
The KX1 uses the existing LED.  Tom has some great directions, follow the
link.
http://www.n0ss.net/k6xx_cw_tun_ind_smd_v2_assy-align_kx1_ver.pdf

73 K2CG
Chuck Gehring

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of STEPHEN W BANKS
Sent: Saturday, April 26, 2008 10:31 AM
To: Elecraft
Subject: [Elecraft] (no subject)

Hello Everyone,

Recently I purchased two of the LED CW Indicator kits through the Eastern PA
QRP Club.  I THINK - - but now I'm not sure - - that the kit is designed to
install in either/both my K2 and in my KX1 rigs.  

In looking over the kit and my KX1, I can't see which button the LED
installs in, or if it's intended to be situated elsewhere.  Is the idea is
to pick one of the three buttons and drill it?  The K2 is no problem as I
received a drilled new button for it, but the KX1 has me guessing.  Tom
Hammond's website has a couple of photos of the completed indicator in place
just prior to buttoning up the KX1, but nowhere is the finished installation
shown that I can see.

Maybe I misunderstood the intent of the kit.  If it is designed to be used
in the KX1, can anyone steer me to where the indicator LED installs?  Does
it peek out of a newly drilled chassis hole someplace?  If so, where?

Any help would sure be appreciated.

Thanks es 73...

Steve Banks
K0PQ
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com