[Elecraft] K2/10 low battery message

[Robert Tellefsen]

Is there some menu setting that would make the K2
think there is a battery installed?  If it tried to sample
the voltage, it would certainly be low :-)
73, Bob N6WG

----- Original Message ----- 
From: "Scott McDowell" <scott1934 at gmail.com>
To: <elecraft at mailman.qth.net>
Sent: Wednesday, April 23, 2008 2:38 PM
Subject: [Elecraft] K2/10 low battery message


> Hello
> Has anyone ever had their low battery mesage
> keep coming on every five minutes on their  k2/10.
> Where does this message originate from?
> I have re-soldered every joint from the power
> input up to the power switch and can't figure out
>  where the power circuit goes from there.
>  All components check good up to that point.
> I even re-soldered the power switch. Anyone ever
> have a bad power switch? The low battery
> messages never comes on during transmit.
> I have the K2/10 connected to the same 30 amp
> power supply that I used on my K2/100, and
> I never had a low battery message on it.
> I don't have a battery installed so that is not
> the problem.
> I never got this message on my K2/100 running
> 100 watts, so I believe the problem is in the K2.
> Any one know where to start looking?
> 73
> Scott N5SM
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com