[Elecraft] Out Board PA

[Dave Van Wallaghen]

Hi David,

I also have my KPA100 and KAT100 in a separate EC2 enclosure and yes you
have to connect the I/O cable from the K2 to either the KPA100 or KAT100 I/O
ports. After the K2 initiates communication with one of those two modules,
you will be able to turn on the PA option in the K2.

Lyle, KK7P, has a nice web page that describes the process of placing the
KPA100 in a separate enclosure and how to hook it all up.
http://www.kk7p.com/k2kpa100.html 
Since you have the KIO2 module in your K2, the bottom end of the page will
pertain to your operation.

73,
Dave W8FGU 

> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net [mailto:elecraft-
> bounces at mailman.qth.net] On Behalf Of David N.
> Sent: Sunday, April 13, 2008 11:00 AM
> To: elecraft at mailman.qth.net
> Subject: [Elecraft] Out Board PA
> 
> I picked up the outboard PA/Tuner Kat100/KPA100
> in one box. I went to turn on the PA in the K2 But
> All it has is (PA --) I cannot change the -- to on/
> off or whatever. Does the Io cable have to hooked up
> for those? I am in the middle of modifying My KI02
> cable to match the KAT100 Which I assume is the Input
> to run the tuner and the amp is this true? Also is
> there any docs on doing this anywhere?
> Thanks
> David KR4OW
> K2+100 4320
> 
> __________________________________________________
> Do You Yahoo!?
> Tired of spam?  Yahoo! Mail has the best spam protection around
> http://mail.yahoo.com
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com