[Elecraft] kpa100 - r33/rfc3

[Don Wilhelm]

John,

The resistance of the choke is quite small in comparison with the 1k 
resistor that you should be able to measure the choke with the resistor 
in parallel.  BUT if you want to check the resistance of the resistor, 
it would be necessary to disconnect one end because the choke would 
predominate the measurement.  You may want to review the ARRL Handbook 
or other resource for information about paralleled resistors.

73,
Don W3FPR

Jferg977 at aol.com wrote:
> suspecting that R33 is shorted, is a resistance  measurement across the 
> R33/RFC3 pair meaningful, or do I need to disconnect one  end of R33 in order to 
> get an accurate reading of its resistance?
>
> John  Ferguson AI4TO  
>
>