[Elecraft] W1 enclosure ideas?

[Dave Van Wallaghen]

Hi Glenn,

I currently sell and enclosure for the W1 that may be ordered in 3 different
configurations, depending on how you want to build the W1. An optional tilt
stand can also be purchased for it as well. I externalized the power switch
(included) and recommend putting the battery holder on the back of the board
for ease in changing. The power and com ports are also accessible. Here is
the link to my site: http://w8fgu.home.comcast.net/~w8fgu/enclosures.html

If this interests you, please contact me directly for a shipping quote to
your QTH.

Hope this helps.

73,
Dave W8FGU

> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net [mailto:elecraft-
> bounces at mailman.qth.net] On Behalf Of ON4WIX
> Sent: Friday, April 11, 2008 6:28 AM
> To: Elecraft Reflector
> Subject: [Elecraft] W1 enclosure ideas?
> 
> Hi all
> 
> I was just looking at the W1 watt-meter/SWR bridge specs. Since I am
> craving
> some solder fumes I thought it would be nice to build this kit, also
> because
> I have no peak reading wattmeter yet.
> I would like to install this kit into a nice enclosure that I could put
> upright or slightly slanted on my desk so all LEDs are clearly visible.
> Have
> any of you done such a thing? Any ideas and suggestions would be very
> welcome.
> 
> Have a nice weekend!
> 
> 73 de Glenn ON4WIX
> 
> K2/100 #5361
> K3/100 #0192
> Two left hands ;-)
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com