[Elecraft] Line out

[Jim Miller]

>From page 20 in the K3 Owners Manual -
............................................................................
.......
LINE OUT

STEREO, transformer-isolated; 600 ohm (nominal)

These outputs should be connected to your

computer's soundcard inputs. The left channel is

main receiver audio; the right channel is sub

receiver audio (if applicable). The outputs are post-

AGC but pre-AF-gain; use CONFIG:LIN OUT to

set the level.

............................................................................
.......

I don't see anything about mono there.  Looks like they mean it only for
stereo connections.

73, Jim


----- Original Message ----- 
From: "ab2tc" <ab2tc at arrl.net>
To: <elecraft at mailman.qth.net>
Sent: Sunday, April 06, 2008 8:24 PM
Subject: [Elecraft] Line out


>
> Is there any harm done using a mono to stereo adapter in the line out jack
in
> order to get the signal (no subreceiver installed) in both channels? This
> will presumably short-circuit the right channel output on the jack. I am
not
> using any any of the pseudo-stereo modes.
>
> Knut - AB2TC
>