[Elecraft] Installing the K3 AGC Mod (SMD)

[Ron D'Eau Claire]

If you have a DMM with a diode check feature, just probe the LED terminals.
When you have the positive lead on the anode the DMM will indicate a forward
biased diode junction and the LED will light up! 

It won't work with modern DMMs in "ohms" scale because they limit the
current too much to avoid damaging parts, but "diode check" works FB. 

Ron AC7AC

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Roy Morris
Sent: Saturday, April 05, 2008 1:12 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] Installing the K3 AGC Mod (SMD)


I am getting ready to install the SMD AGC mods.  The LED chip replacing R101
has two little green dots on it.  Can someone give me the orientation of
this chip.  I don't know which side is the cathode.  Thanks,  Roy Morris
W4WFB _______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com