[Elecraft]K3 SSB Operation Queston

[Greg]

This is almost certainly the case.  Please check the 5-pin header between
the FP and DSP boards to make sure they're mated correctly.  Its easy to
miss this.

Greg
AB7R


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net]On Behalf Of Bryan
Sent: Friday, April 04, 2008 3:48 PM
To: Elecraft
Subject: [Elecraft]K3 SSB Operation Queston


Craig,

I had a similar problem with s/n 181, which turned out to be poor connection
with the front panel.  It  was cured by removing the front panel and
refitting it, taking care to make sure all the connector pins were made.
With original fault the rear panel connection of a microphone worked ok.
Hope this helps.

73  Bryan  GM3AKF
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com