[Elecraft] K2 L33

[Damon - KC5CQW]

Short answer, Yes.
Long answer:
I used the "solder blob" method to tin the wires slightly.
Then mounted L33 and the 1/8w resistor. 
After all of the mechanical connections have been made, I used tweezers to
wrap the wire around the resistor leads. You may find that the solder will
help stiffen up the wire. 
Just don't pull on it!

Hope this helps, 
Damon


Scott McDowell-4 wrote:
> 
> Hi
> 
> I have a question about L33 in the BFO circuit on the K2 I am building.
> The
> wire it is wound with appears to
> have a coating of some kind on it. Should this coating be removed before
> soldering it to the resistor that
> holds it in place? And if so, how can it be removed without destroying it.
> I
> tried scraping the coating off
> but that didn't work. The wire broke. Instead of taking off a couple ot
> turns and using it anyway, I ordered
> a new one. I sent an email to support at Elecraft about this, but they
> don't
> answer emails anymore.
> Thanks
> N5SM
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> 
> 


-----
Damon Wascom KC5CQW
Elecraft K2 #:6351
Build: 12/28/07-01/01/08


-- 
View this message in context: http://www.nabble.com/K2-L33-tp16488156p16489438.html
Sent from the Elecraft mailing list archive at Nabble.com.