[Elecraft] KAT2: C55 Adjustment

[JT Croteau]

Folks,

I am having a hard time doing the Bridge Null Adjustment (C55) on the
KAT2.  The display reads HI pretty much continuously as I adjust C55.
However, every once and awhile it will flicker a number while I am
turning C55 but this is inconsistent.  Before installing R6, you are
to also check U4 pin 1 voltage during tune.  I am showing 4.61V at
this spot.  I have checked, and rechecked T1 multiple times and do not
see any problems.  I also don't see any cold solder joints.

However, is it possible to installed C55 the wrong way?  The manual
wasn't specific on this like it was when installing variable caps
during K2 assembly.

Thanks

-- 
JT Croteau, N1ESE - Manchester, NH (FN42gx)