[Elecraft] mic pin config for the k3 microphone(what Mic r theFT'susing)

[Ed Rodriguez]

Thanks Chris and here is the answer
What is the microphone pin-out on the K3?

The K3 8-pin microphone connector is wired the same as the K2 using the 
Kenwood pin-out. Plus we added a lot more mic pre-amp gain (adjustable) in 
the K3.  There's also a 1/8-inch mono mic connector on the rear panel.  This 
helps with keeping the clutter down during the heat of a contest.  The mic 
source is set from a menu option.



de WP4o, Ed




----- Original Message ----- 
From: "G3SJJ" <g3sjj at btinternet.com>
Cc: <elecraft at mailman.qth.net>
Sent: Wednesday, September 26, 2007 8:48 AM
Subject: Re: [Elecraft] mic pin config for the k3 microphone(what Mic r 
theFT'susing)


> http://www.elecraft.com/K3/K3FAQ.htm#mic%20wiring
>
> Chris G3SJJ
>
>
> Ed Rodriguez wrote:
>> Sorry for the dumb question, but what configuration is the mic pin for 
>> the K3 , ie; Kenwood 8 pin? what microphones  are the field testers 
>> using? what do you all recommend to use, Elecraft is selling the Hand 
>> Mic, how does that preform?
>>
>> thanks, De Wp4o Tampa, Fl     awaiting for the 3rd wave of the K3, 
>> current rig Kenwood TS 950SDX.
>>
>> ED
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com