[Elecraft] RE:K2>Alignment @Test, Part 1, #6249

[Tim Koehl]

Per Rev.G,May 29,2007 Manual
   Greetings All,
...Having made it to Page 44, after the initial power
up to initialize the EEPROM (verified by the INFO 201
display), the K2 was turned off and then back on after
a few seconds, and the display only gives me "ELE",
not
"ELECrAFt", as was to be
expected...Furthermore,tapping
the display switch once did not show the supply
voltage
and current, which is from a battery (12.67vdc @
7A.)..
.."ELE" remains in display. Also, the bar graph to the

left of LCD is not illuminated, but should I expect it
to without any signals at this stage of construction?
...It looks like trouble shooting code "060" might be
applicable for "...partial(incomplete)display", which
is not specifically addressed.  The relays do appear
to
activate when K2 is turned on. ANY past problem
solving
tips to help locate the area of the "glitch" will be 
greatly appreciated.  I am sure there will be more as 
the project progresses.  I read the mail every day, so
anything that helps to get the K2 closer to completion
helps ease the pain of waiting for the third wave K3
distribution...............73, Tim KE5LYT




       
____________________________________________________________________________________
Be a better Globetrotter. Get better travel answers from someone who knows. Yahoo! Answers - Check it out.
http://answers.yahoo.com/dir/?link=list&sid=396545469