[Elecraft] Re: K3 keyer "mode"

[Leigh L Klotz, Jr.]

I also would ask for Ultimatic. As a K3 choice  It's been requested 
before for KX1 and K2 and codespace has been an issue, but can we please 
have it on the future feature list?
Leigh/WA5ZNU
On Fri, 7 Sep 2007 10:08 am, wayne burdick wrote:
> Carsten,
>
> The K3's internal keyer presently has two iambic keying modes, A and B, 
> which closely emulate Curtis mode A and Super CMOS II mode B 
> respectively.
>
> Mode A, which I use, is the default. (I think it's less error prone 
> than mode B, but say this in a crowed bar and you'll start a fight for 
> sure.) Some operators like mode B for its 
> element-insertion-on-squeeze-release, either because it permits faster 
> keying or because they learned using a mode-B keyer.
>
> We plan to allow for turning the dot/dash memories off completely in a 
> future firmware revision.
>
> 73,
> Wayne
> N6KR
>
>
> On Sep 7, 2007, at 8:15 AM, Carsten Steinhöfel wrote:
>
>>
>> Hi there,
>>
>> I haven't found anything in the archives or the FAQ. I have a question 
>> regarding the keyer in the K3. Which keying "mode" does it use? If it 
>> has a dot/dash-memory, can that be switched off?
>
>
>
> ---
>
> http://www.elecraft.com
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com