[Elecraft] Pomona Adapter Query

[Sandy]

Banana plugs should fit into the top of the binding posts.  Also on the 
Pomona adapter they will fit into the two holes directly below the bases of 
the binding posts in the black shank.

Pomona makes a VERY nice banana plug with a banana socket on the other end. 
The cable for it goes thru a small spigot strain relief on the side of the 
plug, and the wire is held with a common 8-32 set screw which is accessible 
thru the back socket part of the plug with a small screwdriver.  They are 
VERY nice banana plugs and well suited to portable antenna use.  You can 
stack several plugs together easily for laying out radials etc.

The Pomona part number for that plug is #1825.  They come in black and red 
plus other colors.  I just use the black and the red ones.  Allied 
Electronics, Newark and probably others have then in stock.

73,

Sandy W5TVW
----- Original Message ----- 
From: "Scott Walker" <n3sw at worldnet.att.net>
To: "elecraft reflector" <elecraft at mailman.qth.net>
Sent: Monday, September 03, 2007 4:15 PM
Subject: [Elecraft] Pomona Adapter Query


I have the recommended Pomona BNC-to-dual binding post adapter for use with 
my KX1.  It looks like some kind of wire termination might fit into the ends 
of the binding posts.  Has anybody got a recommendation for what kind of 
wire termination would fit snugly into those openings?  Banana plugs are too 
large.  It would be nice to have a plug-in option, in addition to crimping 
bare wires.
-Scott N3SW
-New Cumberland PA
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com


-- 
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.5.485 / Virus Database: 269.13.3/986 - Release Date: 9/3/2007 
9:31 AM