[Elecraft] My K2 is a Low Rider!

[JT Croteau]

On 9/3/07, k4zm <k4zm at comcast.net> wrote:
> It sounds like you have the bottom plate mounted 180 degrees out or have not
> installed the bail assy.  The bottom should be installed so that the bail
> assy is located near the front of the K2.  Also if mounted 180 degrees out I
> don't think you can install the two screws in the middle of the bottom
> cover.  These are important in making the PLL a stable unit.

Nope, everything is installed correctly.  Bail was a pain to install
but I finally got it  installed just fine.  It isn't off by much but
noticeable when sitting flat on the desk.  It's probably a 1/16th or
1/32nd shorter in the front but I haven't measured yet so maybe my
eyes are playing a trick on me.

-- 
JT Croteau, N1ESE - Manchester, NH