[Elecraft] K3 Pre-release Assembly Manual......later this week?

[Bill W5WVO]

I dunno, but I would have done it in Adobe Illustrator. That's my main 
graphics tool. Could have been that, or Corel Draw, or any other vector-based 
graphic arts program. There's nothing super-sophisticated in there, just some 
well-executed use of gradient fills. Nice work! I couldn't have done it better 
myself, I don't think.  :-)

(What you see on the page, of course, is a relatively low-resolution 
rasterized image of the vector artwork. The original vector artwork would be 
resolution-independent, such that you could embed it in a PDF or other 
Postscript-based environment and zoom into it to see the finest details.)

Bill / W5WVO
Technical writer / editor / graphic artist


Edward Dickinson, III wrote:
> I'd like to know what program this image was created with.
>
>
> Regards,
> Dick - KA5KKT/4
>
> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Gary Hvizdak
>
> BTW, have y'all seen the newest K3 Front Panel rendering in the K3
> folder at <http://www.elecraft.com/K3/K3%20FP%20drawing_web.jpg>?  I
> noticed it yesterday morning, but don't recall seeing a post
> announcing it.
>
> Although it's not a high resolution image...
> ---------------------------
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com