[Elecraft] Needing a little help/suggestion((Problem Fixed))

[Tony Martin W4FOA]

Gus,
I was getting a "flashing C"....after I turned the power off completely and 
turned the K2 on again, it cleared up the problem.  I guess I inadvertantly 
must have pressed the engaged the VOX button...thanks for the tip.
Kind Regards,
Tony, W4FOA


----- Original Message ----- 
From: "Augie Hansen" <augie.hansen at comcast.net>
Cc: <Elecraft at mailman.qth.net>
Sent: Saturday, September 01, 2007 10:35 AM
Subject: Re: [Elecraft] Needing a little help/suggestion/reminder NO TX 
POWER


> Tony Martin W4FOA wrote:
>> ...
>> My K2 has been sitting idle for several weeks.  Fired it up this morning 
>> and all seemed just fine except that I note there is no LED power 
>> indication on the meter.  All else seems to  be just fine and dandy.  The 
>> power level control shows the varying power level as I increase or 
>> decrease it....just no power output apparently.  No sign of a transmitted 
>> signal on a secondary receiver.  The K2 receiver works just fine.
>>
>> I'm thinking I may have inadvertantly pushed a buttom that shouldn't have 
>> been pushed?
>>
>> Appreciate some guidance here....thanks in advance and since I've 
>> probably done something stupid, please forgive me, hi.
>
> Is it possible you are in Test Mode? Try holding the VOX button until you 
> see the mode display (TEST or OPER). Also a flashing C on the display 
> indicates TEST vs a solid C to indicate OPER mode when in CW mode.
>
> Gus Hansen,
> KB0YH
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
>
> -- 
> Internal Virus Database is out-of-date.
> Checked by AVG Free Edition. Version: 7.5.476 / Virus Database: 
> 269.11.19/953 - Release Date: 8/14/2007 5:19 PM
>
>