[Elecraft] k3 - what are your settings?

[johnny]

Hello Group,

Under the firmware 1.41, the NR is far better than the KDSP2 in K2.  What kinds of NR settings are you using?  I only use 'NR 0' and it seems working well.

BTW, when to use the IF Noise blanker and when to the DSP IF blanker?

I am using a dynamic moving coil hand mic from Adzen, Japan.  The TX EQ settings at  3.2K + 1db, 2.4K + 2db, the rest are 0db.  I get good audio reports.  How about your settings?

I would like to make sure that I am familiar with all the goodies of K3 before doing an A/B comparison with my IC7800.

73

Johnny Siu VR2XMC
K3# 46