[Elecraft] KRX3 2nd receiver

[Craig Rairdin]

I assume there will be standoffs to install, so the top and bottom covers
will have to be removed. Based on where the KRX3 sits, you might have to
remove the stiffener that runs across the top. Not sure about that.

The benefit of waiting would be that it could be installed before the
top/bottom covers are put on in the first place. On the other hand, there's
not much work required to remove the covers. I personally wouldn't wait. I
built my K3 when I received it, and have a KRX3 on order.

Craig
NZ0R
K3/100 #25

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Manuel Maseda
Sent: Saturday, November 24, 2007 9:39 AM
To: elecraft at mailman.qth.net
Subject: [Elecraft] KRX3 2nd receiver


 
Does anyone know how difficult it will be to install the 2nd receiver (KRX3)
after the K3 has been initially assembled?  I'm just wondering if I should
wait to build my K3 (scheduled to arriver in December) until after the KRX3
arrives in January.

Manuel  W4SSB

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com