[Elecraft] Problem to save my K3 configuration

[Thomas Norff]

Has anyone seen this error? 

Using the "K3 Firmware Update Downloader (Version 1.0.11.21)" i get always
the same problem with the function "save K3 configuration as" under the tab
"configuration".
The saving proccess stops unpredictable.

In a small portsniffer output i can see that the response from the K3 is
alright referring to the format.
But some characters are wrong, which seems to be the reason why the software
stops the process.
Inside the stored file you can find "*error reading EEPROM at ...".

My K3 has the current MCU and DSP software installed and i've checked it
with all available baud-rates.
Based on the fact that my previous firmware upgrades were successful i would
assume it is not a problem with the interface.

Any comments ?

Thanks,
Thomas, DM7TN
s/n 78