[Elecraft] K3 selectivity display?

[Jeff Stai]

hi Barry - Look at the owners manual for the Display page (in my copy here rev B1 it is on page 12).

On the lower right of the display are 7 digits, which are used to display a multitude of things, 
normally the VFO B setting - but also the CW decode and parameter changes.

Just sitting there the K3 does not display the BW, but if you turn the WIDTH knob this lower right 
display will show you the setting as it changes. This is also the case for the POWER setting and 
many other settings. When you stop turning the knob the display reverts back to VFO B (or CW or DATA 
decode if you have that enabled.)

73 - jeff wk6i

Barry N1EU wrote:
> Is there any numeric indication of the K3 rx bandwidth on the display?
>  I see the trapezoidal analog display of relative bandwidth, but if
> the dsp bandwidth is set to 300hz, does the K3 indicate such directly
> to the operator?
> 

-- 
Jeff Stai               jds at twistedoak.com
Twisted Oak Winery      http://www.twistedoak.com/
Winery Blog             http://www.elbloggotorcido.com/