[Elecraft] Red and Green Enamel Wire

[Gary McKelvie]

Hi Guys,

Thanks for the replies from all of you, Tom N0SS, Don W3FPR and Bob N7XY.
I thought that different gauges would be in use, especially when I 
saw how small RFC 1 and 2 are in the KSB2 module :) At first I 
thought they were washers when I was sorting the parts out and doing 
the checklist :)
I have used the red and green enamel supplied with each module, 
keeping what's left over as spares.
Tomorrow RFC 1 and 2 and the two transformers will be added to the 
SSB board, Then I'll get started on the RS232 board as I can't use a 
rig now without CAT control, once you start to use CAT control, you 
just can't imagine controlling a rig any other way :)

73 Gary G7USC

At 23:06 21/05/2007, you wrote:
>Gary,
>
>The wire sizes do vary from kit to kit.  Most of the wire is #26, 
>but the KSB2 uses some #28 for the toroids that are small and with 
>many turns (where #26 will not fit).  The KPA100 requires the higher 
>current rating of larger wire for the LPF toroids, and the KAT100 
>uses an even larger wire.
>
>Yes, you can use the spare wire, but be aware of those instances 
>where a smaller or larger wire is required.
>
>73,
>Don W3FPR
>
>Gary McKelvie wrote:
>>Hi to the list,
>>Just a quick question is the enamel wire, both the red and green 
>>the same wire used throughout all the kits/modules the same?
>>I.E could I use any spare red or green from building the basic K2 
>>in the KSB2 module or the 100w PA?
>>73 de Gary G7USC
>>Gary McKelvie
>>G7USC
>>Web : www.garym.org.uk
>>Mobile : +447968501863
>>MSN Messenger : gm7usc at hotmail.com
>>So Long and Thanks for all the Fish
>>_______________________________________________
>>Elecraft mailing list
>>Post to: Elecraft at mailman.qth.net
>>You must be a subscriber to post to the list.
>>Subscriber Info (Addr. Change, sub, unsub etc.):
>>http://mailman.qth.net/mailman/listinfo/elecraft
>>Help: http://mailman.qth.net/subscribers.htm
>>Elecraft web page: http://www.elecraft.com
>
>Gary McKelvie
>G7USC
>Web : www.garym.org.uk
>Mobile : +447968501863
>MSN Messenger : gm7usc at hotmail.com
>So Long and Thanks for all the Fish