[Elecraft] K2 Improvement Ideas

[Jozef Hand-Boniakowski]

It would seem to me that new rigs today might benefit from a built infra 
red or wireless CW key connection.  Elecraft could then also sell as an 
accessory a wireless paddles, perhaps even a wireless touch paddle.  Of 
course the same could be for microphones for those that are not CW only.

Jozef WB2MIC


drewko1 at verizon.net wrote:
> I had been thinking about having a filter parameter memory card, where
> you could store the bandwidth/bfo figures from a number of different
> alignments and instantly recall and load them. Say you had five banks,
> you could have four bandwidths at each of five different
> sidetone/offsets. But I don't know enough about this to know why even
> this limited option (let alone continuously tracking filters) wouldn't
> be practical.
>
> 73,
> Drew
> AF2Z
>
>
> On Tue, 08 May 2007 22:21:04 +1200, "Nigel & Beryl"
> <hayton at xtra.co.nz> wrote:
>
>   
>> I would like to see the ability to toggle or step through say three side
>> tone settings and have the CW filters automatically track the changes.
>> On a occasions, especially when the filter is set narrow and the signal is
>> weak, the filter ringing and the background noise level can mask a
>> particular sidetone frequency.   Being able to change the CW sidetone can
>> again un-mask the signal.
>>
>> 73,  Nigel ZL2DF
>>
>>     
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
>