[Elecraft] N0SS Zero Beat detector too active

[Don Wilhelm]

Tom and all,

Thanks to all who responded.  I promise to make a permanent note of it 
so I can refer others to it should they ask (I just can't remember 
everything, and I have earned the 'senior moment' excuse to fall back on 
if necessary <G>).

The collective memory of this group is a valuable resource.  Thank you all.

73,
Don W3FPR

KJ3D wrote:
> Don,
> 
> You cannot possibly imagine how pleased I am to be able to answer one of
> YOUR questions!
> 
> The resistor is a 93.1 K and is supplied as a SMD.
> 
> 73,
> 
> Tom 
> 
> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Don Wilhelm
> Sent: Monday, May 07, 2007 8:04 PM
> To: Elecraft reflector
> Subject: [Elecraft] N0SS Zero Beat detector too active
> 
> Folks,
> 
> I recall seeing a post sometime back about reducing the input to the N0SS
> tuning indicator, but I have not been able to locate it.
> 
> As I recall it was only a series resistor, but can someone tell me the value
> used before I begin re-inventing the wheel.
> 
> While I have K2 SN 00020 open on the bench, I would like to add this, my
> zero beat indicator is way too sensitive.
> 
> 73,
> Don W3FPR