[Elecraft] TenTec 701 Hand Mike wiring

[Mike Geddes]

Great Don.  Thanks!

73,
Mike
N4JX

----- Original Message ----- 
From: "Don Wilhelm" <w3fpr at earthlink.net>
To: "Mike Geddes" <geddes at tampabay.rr.com>
Sent: Monday, May 07, 2007 7:23 PM
Subject: Re: [Elecraft] TenTec 701 Hand Mike wiring


> Mike,
> 
> You are correct - wire the Yellow lead to pin 1, Black to pin 2, Braid 
> to pin 7 and Red to pin 6.
> 
> You do not need any resistor on the mic jack, but if you already have a 
> 5.6k mounted between pins 1 and 6 (so the Elecraft mics will work), the 
> TenTec mike will work fine with it installed.
> 
> 73,
> Don W3FPR
> 
> Mike Geddes wrote:
>> Greetings Elecrafters!  Just received my TenTec 701 hand mike in the 
>> mail today, for use with my K2.  I am going to jumper the K2 straight 
>> across (the Elecraft mode), and rewire the 701 to fit it.  Can anyone 
>> confirm the wiring on the 701?  I think it is:
>> 
>> Braid - Ground
>> Black - PTT
>> Red - Power
>> Yellow - Microphone
>> 
>> Please confirm if you are able.  Thanks in advance.
>> 
>> 73,
>> Mike
>> N4JX
>> 
>> K1/4  2319
>> K2     6042
>