[Elecraft] Re: K3 Power (clarification: *quiet* switcher!)

[Fred N. van Kempen]

I use a 60-amp switcher from Diamond (GSV-6000) for driving
both the K2/100 *plus* the HLA-300 amp (45A) without any
issues.  The supply is clean.

One note: most smallish generators (think 'field day' !) do
hate this power supply.  I have seen 3KVA diesel units go
into a panic mode when the GSV was turned on.  Dunno what
that is about- my own (diesel) generator seems OK with the
very same supply.

--f
 

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of wayne burdick
Sent: donderdag 3 mei 2007 4:50
To: wayne burdick
Cc: elecraft at mailman.qth.net
Subject: [Elecraft] Re: K3 Power (clarification: *quiet* switcher!)

> Not yet, but I'd use a 4-6 amp supply for 10 W and 20-25A for 100 W. 
> To minimize noise, use a linear supply or a

*quiet* (low RFI)

> switcher.

Wayne


---

http://www.elecraft.com

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com