[Elecraft] K2 Alignment Part I

[Gerard Provoost]

Hi Folks,

I have a strange behaviour with my K2 #6026 in the alignment and test 
procedure at page 43 of the manual. All went ok, untill after power up I 
tapped Display, the display said St L 040 and stayed in that menu, untill I 
tapped Menu, then everything was normal and stayed normal - untill next 
power up. I tried to reset the EEPROM, by powering up with 4+5+6 held, but 
this had no effect. It seems nothing is reset. All other tests went ok.
I checked and rechecked soldering.
If anyone has an idea, please.

73, Gerard PA1GP
g.provoost at planet.nl