[Elecraft] Zero beat WWV

[David Wilburn]

I have setup Spectogram, and have 500 & 600 Hz markers setup.  I then 
set the K2 to 10000.00, in U mode, and adjust the frequency until I have 
either 500 or 600 Hz depending on which minute it is (odd minutes being 
a 600 Hz tone and even being a 500 Hz tone, even though this seems 
backwards of how it should be).

I then used this zero beat reference, and the procedure on page 101 of 
the K2 manual so that I have it down to U or L mode is zero beat at 
9999.99.

I notice the calibration on page 101 of the K2 manual says to use U or L 
mode.  My question, is how much should the offset be when I go to CW 
mode?  I am trying to track down why my CW RX frequency is so far from 
my USB frequency (was 1500 Hz off at one point). I have it better, but I 
am sure the issue is with how I did the alignments.
-- 

David Wilburn
dave.wilburn at verizon.net
K4DGW
K2 #5982