[Elecraft] LO BATT

[Manuel Wilches]

Many thanks for the generous comments and suggestions.

I believe the cables to the power supply were a bit loose. The situation improved quite a bit: 13.1 v o 11.6 v on the K2 display. The jumper on the control board is on the INT position. I did not change it.

If I put a DMM at the power supply terminals I read: 13.6 v and then 12.6 v on transmit. The RF reading on the K2 display reaches full scale when I transmit.

Are these voltage drops reasonable ? Thank you.

73
Manuel
LU5OM
CT4IK
K2/100 # 5310